Skip links


Compliance with the protection standards is a matter of course!

Safety shoes are tested and certified according to EN 20345:2011.
In EN 20345:2011, all requirements for safety shoes are defined and split into basic and additional requirements. Examples of basic requirements:


Unless the shoe has an insole board, the insole must be non-detachable..


Toe protection

  • Safety toe protection caps must be non-detachable.
  • The toe cap must be equipped with an edge protection of a length of 5 mm minimum below the toe cap and 10 mm minimum in the opposite direction.
  • The inner length of the toe cap must not exceed a certain required value (size 42: 39mm).
  • Resistance against shocks of 200 joules

Specific ergonomic features

The specific ergonomic features have to be considered positive on the basis of 3 test persons and 3 different foot sizes. Typical daily activities are simulated, such as:

  • Normal walking
  • Walking on stairs up and down, 1 min.
  • Kneeling/cowering


Slip resistance

The test shoe is put on the ground, loaded with a vertical force and moved horizontally on the ground surface (alternatively, the ground surface is moved against the shoe).
The frictional force is measured and the dynamic friction coefficient is calculated.

  • Detergent on ceramic tile = SRA
  • Glycerine on steel ground = SRB
  • Both tests passed = SRC
Symbol Requirement / properties Required protection
P Penetration resistance of the outsole ↑ 1100 N
E Energy absorption in the heel section ↑ 20 Joule
A Antistatic shoe Between 0,1 and 1000 MΩ
C Conductive shoe ↓ 0.1 MΩ
WR Waterproof
WRU Water resistance and absorption of the upper materials ↑ 60 min.
HI Heat insulation Test at 150 °C
CI Cold insulation Test at -20 °C
HRO Resistance to heat contact Test at 300 °C
M Protection for metatarsus
AN Protection for ankle
CR Cut resistance
SRA Slip resistance on ceramic tiles / detergent
SRB Slip resistance on steel ground / glycerine

There is only a protection against the dangers which are designated on the shoe.
The most common requirements are summed up in the following protection classes:

Category Basic Requirement Additional Requirement
S1  √ Closed seat region, antistatic, energy absorption of seat region
S2 As for S1, but also water penetration and water absorption of the shoe uppers
S3 As for S2, but also penetration resistance of the outsole and cleated outsole
Safety Footwear EN ISO 20345 S1 S2 S3
Basic requirements  √  √  √
Closed seat region  √  √  √
Resistance to fuel oil  √  √  √
Antistatic properties  √  √  √
Energy absorption of seat region  √  √  √
Water penetration/absorption  √  √
Penetration resistance  √
Cleated outsole  √
Return to top of page